Sensing LED Light Driver,EMC,CE,ROHS,Non-isolated,Isolated

Size:  193(L)*17(W)*10.5(H)mm

1.Application: Infrared sense light  

2．Electrical Characteristic

2.1 Rated input Voltage 

   It is normal for 100Vac to 240Vac AC inputvoltage.

 2.2 Input Voltage Range

   The charger shall operate from 100Vac to264Vac and the range switching is unnecessary.

2.3 Rated Frequency

   It is normal for 50Hz or 60Hz and singlephase.

2.4 Frequency Range

   The charger shall operate with an inputfrequency from 47 Hz to 63Hz

2.5 Steady AC Current 

  Maximum steady state input current is 500mA (Max)  Measured at 100Vac input and maximum load.

2.6 Peak Inrush Current

  With cold starting, the peak inrush current should less than 30A(at 240Vtest).

 2.7 Efficiency

85% min. measured at 110Vac and 240Vac inputvoltage,maximum load and include the DC cable loss.

2.8 Rated Output Current 

  The output current will be performed from 190mA±5% at CV mode

  2.9 Output Voltage

  Full voltage：68V~84V

 2.10 Rated Power

  This Charger is capable to support 18Watts Max continuously at allspecified conditions.

2.11Output Ripple and Noise

   Output ripple voltage isless than 10V p-p(I=240mA) Measured methods:

   Performed by 20MHzbandwidth in oscilloscope.

   Applied 0.1uF ceramiccapacitor and 10uF electrolytic capacitor across output

   terminals Measured at theend of out cable,

2.12Test Circuit

If the test is to be made on a specifiedcircuit,be sure to use the following circuit.

2.13 Output Short Circuit Protection

Short circuit occurred on output shouldnot damage to the power supply. The power supply will be automaticallyrecovered.

3．Sensor Characteristic

3.1Sensor  Type 

   Pyroelectric infrared sensor.

 3.2Sensing  Distance 

   Using 120-degree fly's eye Fresnel lens, 25degrees in the environment, sensing distance of 4-7 meters in front of.

 3.3  Induction angle  

   120°MAX 

3.4  Induction  latch time  

     This feature lighting sensor lights into standby after a period of timedoes not lock sensor, so the sensor IC affected by the status change for 1-3s;

  3.5  Induction  delay time 

     This feature is sensitive to human action after, LED lights into the100% light, when the body leaves the sensing area, the delay time of 100% of light.